2x4 project
its a nightstand i built out of a 2x4 for reddit woodworking.
finished pics first
this photographs pretty well
my terrible attempt to make a Foureyes inspired nightstand
in profile about 27 inches tall
Getting the 2X4 in a pandemic in the rain
Nice kiln dried !
got 2 incase i mess up
Cody dog approved
started by ripping of resawing the length of the 2x4. to make a panel. This is 3 sections of 2x4 glued up the first 2 are book matched
then i used a jig saw to start cutting legs. i got two out of the width of a 2x4
saving scraps
trying to figure out leg angle
that panel though !
all mitered ! tried to keep the wrap around grain
scraps after the mitre
other legs from 2x4 width
bleh maths !
here are my working parts. legs are 3 pieces front back and what i called Gussets
basically i wanted to join the 3 pieces. dowel the legs together and then biscuit joint the legs to the gussets
HF doweling jig is just a little off, but so am i
leg glue up with dowels
just a beauty shot of a new plane on the box top
i left one part of the leg long because i didn't trust my measurements
cut off the long leg after i was sure and glued it into the legs to make an A frame ! just glue no dowels
attached the gusset with a frame legs. looks like the Atlanta braves logo. Go Dodgers
lots of glue and lots of sanding
had to see it dry fit
before and after stain. legs are Kona it looks like tiki bar furniture
that box though
thought about mounting the legs lower put it was too unstable
joined the box to the completed legs with 3/4 inch dowels . I should have just glued the legs on for stability
there it is with all the scraps
after staining and the final assembly i rubbed it down with danish oil
minus the saw dust of course
some of my hand drawn notes on this