Cake Stand
For the scrap wood challenge, I made a cake stand for my neighbor who is opening a bakery
The requisite scraps... maple, walnut, pakauk and purpleheart
Pieces Glued up to be the spindle
Getting ready to turn the spindle
Top glued up. Just ran a few pieces through the table saw to get uniform thicknesses on each side
Planed top (bad snipe, need to work on my planer)
Bottom turned on the lathe.
Oooh, happy with the transition from bottom to spindle. Was worried about it
Through together a quick and dirty circle cutting jig. Not terrible happy with it. The nail let it move a bit so I had some cleanup to do on the edge afterwards. Thankfully, I rounded over the edge on the bottom which helped
Top cut! Lessons learned, will make a better jig for next time out of plexiglass
Dry fitting parts, used a 1/4" dowel for alignment
Getting the stripes lined up
Drill for weight while the glue dries
Two coats of Gel Urethane, will do 3-4 more, but good enough for pictures
Beautiful work! Thanks for sharing.